Water Repellent Chemical

Our product range includes a wide range of 103 dr fixit repellin wr.

103 Dr Fixit Repellin WR

Request Callback

₹ 411 / Litre Get Latest Price

Product Brochure
Coverage6 sqmt/ltr
TypeLiquid
ColorClear to Pale Yellow
Packaging Size1 litre
BrandDr Fixit
CategoryWaterproofing Coating
Grade StandardAnalytical Grade
Specific Gravity0.02 gm/ml
Shelf Life18 Months
Water Absorption10%
Packaging TypeBottle
Form Of ChemicalLiquid
Non Volatile matter5%
Flash Point40 Degree C
Surface Dry Time25 minutes
Usage/ApplicationConstruction

Minimum order quantity: 20 Litre

Description :
Dr. Fixit Repellin WR is composed of Siloxane & Silane polymers dispersed in high boiling point solvent. It is used as water repellent of concrete & cementitious vertical walls of building because it penetrate deeply into thesubstrate & provides an effective water repellent protective coating. It does not chang the appearance of the substrate & is UV resistant.
Typical Applications :
  • Water repellent treatment for -
  • Clay brick surfaces
  • Concrete, mortar
  • Mangalore tiles
  • Natural and artificial stones
Features :
  • Ease of application - Ready to use, brushable or spray applied.
  • Staining - Clear coating does not stain the treated surface.
  • Appearance - Does not change the appearance of exterior decorative coating.
  • Economical - Cost effective.
  • Penetration – Due to low viscosity penetration is high, which provides the hydrophobic zone.
Method of Application :
Surface Preparation
  • Surface should be dry and free from all debris, dirt, oil, grease, wax and all other contamination, which could prevent penetration.
  • Clean the saturated dirt of surface by thorough wire brushing, cleaning with compressed air followed by water washing.
  • De grease oil & grease by using appropriate solvents.
  • Allow the surface to dry completely before the application.
  • Seal the cracks using Dr. Fixit Crack-X products.
Application :
  • Apply one liberal coat of Dr. Fixit Repellin WR, by brushing evenly on the prepared surface.
  • Apply second coat wet on wet, to improve the penetration rate & performance.
  • Allow it to dry for 24 hrs.
Precautions & Limitations :
  • Do not dilute.
  • Close the container lid properly after use
  • Before applying over the natural stones like sand stone, slate or Dhollpur sampling should be done on a small area to check its suitability.
  • Before taking up application on a large area, it is advisable to check the performance of the product on a relatively small area.
Health & Safety :
  • Use rubber hand gloves & safety goggles, while using Dr. Fixit Repellin WR.
  • In case of contact with skin, wash with plenty of water.
  • Keep out of reach of children’s.
  • Do not smoke during application
X

Contact Us

Lokesh Kumar (Owner)
Pratham Associates
Ground Floor, 24/9, Block S-24, Sanjay Place, Civil Lines, Behind Of Nova Hotel
Agra - 282002, Uttar Pradesh, India

Get Directions
Send Email
Share: